







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Pinole, CA: What It Involves and What It Costs
A chain link fence in Pinole, CA typically runs $3500 – $9000 for a standard residential lot, with most single-family properties landing in the $4200 – $6500 range once a wind-rated top rail, a walk gate, and a quality privacy slat package are included. A straight run of 150 linear feet with two gates usually takes one to two days on site once materials arrive, and we handle permits and utility locates in that timeline. Call (833) 700-4611 for a free on-site estimate with line-item pricing.

How We Run a Chain Link Fence Job, Start to Finish

Every job follows the same five-stage sequence. Here’s what actually happens and when.
Stage 1: Site walk and layout (day 1, about 60 – 90 minutes)
We walk the property line with you and mark post locations with flags and string. You’ll need to know your property line before we start – if there’s a survey marker dispute with a neighbor, that conversation happens now, not after 40 bags of concrete have set. We take grade shots on sloped lots so the fabric follows the terrain rather than floating above it in spots.
Stage 2: Utility locates and permitting (day 1 to week 3, depending on scope)
We file a USA ticket so the locator marks gas, water, and telecom lines within the 2-business-day window California requires. If your project triggers a fence permit with the City of Pinole, we submit the plot plan and wait out plan check – usually two to three weeks for a straightforward residential fence. Fences under 6 feet with no retaining wall typically skip a permit, but we confirm rather than assume.
Stage 3: Demolition and post setting (day 1, 4 – 6 hours)
Old fencing comes out and goes to the transfer station. Posts go in at 8-foot or 10-foot spacing, set at three feet deep in concrete. The concrete needs at least 24 hours to cure before we hang rails, so on a full job we set posts in the morning and the concrete sits overnight. On aggressive clay lots we add 6 inches of gravel drainage at the base of each hole so water moves away from the post, not into it.
Stage 4: Rails, fabric, and tensioning (day 2, 5 – 7 hours)
Top and bottom rails get assembled, then the fabric runs out and gets stretched with a come-along until it rings when you tap it. You’ll be asked at this point where you want gates placed and which swing direction feels right in daily use.
Stage 5: Gates, slats, and walkthrough (day 2, 2 hours)
Gates get hung with adjustable hinges, checked for latching, and adjusted so they swing closed on their own. If you ordered privacy slats, they install last. We walk the finished fence with you, show you the tension, and hand off the written workmanship warranty.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Fence Options You’ll Choose Between
Most of the decisions that move the price happen before the first post goes in. Here’s the honest breakdown.
- Gauge: 11.5-gauge galvanized is fine for a backyard run; 9-gauge holds up much better if kids climb it or you’re bordering a busy edge. The heavier gauge adds roughly 15% to material cost and roughly doubles the structural life. Most Pinole homes are best served by 9-gauge.
- Coating: Galvanized is the baseline. Vinyl-coated (also called color-bond) costs about 20 – 25% more but handles the Bay Area’s airborne moisture better and looks less industrial. A few national brands make coated mesh in black and green that read almost invisible from a distance.
- Post diameter: 1 5/8-inch posts are the residential standard. 2 3/8-inch posts cost more but matter on tall fences or exposed ridge lots where wind loads are heavier.
- Height: 4 feet, 5 feet, 6 feet. Pinole’s typical backyard fence runs 5 or 6. Above 6 generally needs a permit.
- Privacy slats: Vertical slats add roughly $700 – $1600 for a 100-foot run depending on density and color. They don’t block wind; they block sight.
- Gates: A walk gate runs about $250 – $450 installed. A double-drive gate starts near $900 depending on width.
- Retaining considerations: If the fence follows a slope, expect additional labor for stepped panels or racked panels – one of the biggest variables on Pinole hillside lots.
What Chain Link Fence Costs in Pinole, CA
Plan on $3500 – $9000 for the job, with a typical residential installation landing somewhere in the middle. That range covers materials, labor, disposal of the old fence, and a walk gate.
Here’s what pushes a chain link fence job toward one end of the range or the other:

- Linear footage: Every 25 linear feet adds roughly $500 – $700.
- Soil and slope: Pinole’s hillside lots often need deeper post setting, stepped layout, or a short below-grade retaining correction. That adds hours of labor.
- Material grade: Going from 11.5-gauge galvanized to 9-gauge vinyl-coated is roughly a 30 – 40% material upcharge.
- Gates and access: A single walk gate is baseline. Additional or double-drive gates add cost and hardware.
- Site access: A narrow side yard or a hillside rear lot where our equipment can’t reach adds manual haul time.
- Permits and surveys: A permit runs a few hundred dollars in fees. A boundary survey, if needed, is separate and typically $400 – $900.
Every written estimate we hand you is line-item: footage, gauge, post spec, gates, permit fees, disposal. The number on the estimate is the number on the invoice. Nothing gets added mid-job without your signature.
See the difference
Before
After
Before
After
Before
AfterWhat Pinole Lots Specifically Do to a Chain Link Fence Job
Pinole’s clay soil is the single biggest difference between a fence here and one 15 miles inland. That expansive clay swells with the winter rains and shrinks through the dry summer, and the win/lose cycle pushes and pulls at every post footing. On sloped lots off Pinole Valley Road, the movement is amplified, and posts set the same depth as a flat-lot job will lean within a season or two. We plan for it: deeper footings, drainage gravel at each hole, and on the steepest properties a short footing pour that locks the post against the shrink.
Housing stock plays in too. The mid-century ranchers and 1960s – 70s tract homes through the older parts of Pinole often sit behind aging back fences that have done their 40 years, while newer hillside developments push fences to hold grade on sloped lots and often need a small retaining check first. The weather drives the rest – dry summers, wet winters, and that seasonal drainage question we look at before we ever set a post. If your fence runs along a lower property edge where water pools, tell us at the walk-through.
We cover all of Pinole, including ZIP 94564, and often work in the surrounding {Hercules, El Sobrante, Rodeo, and San Pablo} area as well. If your project is broader than just the fence line, our Fence Installation in Pinole page covers the full scope, and homeowners often pair this job with ADU Site Prep & Utilities in Pinole when they’re separating a yard for a new structure. For broader material and style questions, our Fence Installation service hub has the detail. A prefab unit from a manufacturer like Boxabl or Plant Prefab set in a back yard also commonly needs the fence line moved or replaced alongside it, and Door Installation in Pinole is a natural add-on when the gate opens onto a new accessory structure. For a full look at everything we do here, see Pinole.
Serving Pinole, CA – Our Local Coverage Area
We serve Pinole and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Pinole

A standard residential chain link fence in Pinole takes one to two working days on site once materials arrive. Add two to three weeks if the project requires a City of Pinole permit and plan check, and add a few days for material lead time if you’ve chosen a specific vinyl-coat color. Call (833) 700-4611 and we’ll give you a real date range during the free estimate.
Fences at or under 6 feet on a standard residential lot typically do not require a permit in Pinole, but anything taller, on a slope, or tied to a retaining wall generally does. We confirm permit requirements during the site walk and, when one is needed, we prepare and pull the permit for you. Call (833) 700-4611 to schedule the walk.
Chain link fence in Pinole costs $3500 – $9000 depending primarily on linear footage, gauge, gates, slope, and permit scope. A standard 150-foot residential run with one walk gate usually lands in the middle of that range. Call (833) 700-4611 for a free written line-item estimate – the number you see is the number you pay.
Yes, with the right footing detail. Pinole’s expansive clay moves seasonally, so on sloped lots we set posts deeper, add gravel drainage at each hole, and on the steepest properties pour a short footing that locks the post against shrink. Standard homeowner post depth that works in flat, sandy East Bay towns is a poor fit here and is the most common reason fences lean within two years.
Every chain link fence we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. Our technicians have up to 12 years of experience, and all are background-checked and arrive in uniform. Calls are answered by a live person 24/7, so if you notice a gate sag or a post issue after the job, you’re talking to someone immediately.
Get Your Free Chain Link Fence Estimate in Pinole
Call (833) 700-4611 to schedule a free on-site estimate for your chain link fence in Pinole. We’ll measure the run, check the slope and soil, walk you through the gauge and coating options that fit your property, and hand you a written line-item quote before you commit to anything. Current promotions include a free project estimate and design consult, 0% financing for 18 months, and $1,000 off projects over $10,000. A live person answers – no voicemail.
Written by the team at Groundwork Construction Co.












