







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Emeryville, CA: What It Takes and What It Costs
Door Installation in Emeryville, CA usually runs $450 to $2,800 per door, depending on whether you’re swapping an interior slab in a Bay Street loft or hanging a pre-hung exterior entry with a new frame, hardware, and rolling-code opener on an alley-load townhome. A single interior door is a few hours of work. An exterior entry or garage service door with framing repair and finish is a two-day job, and permits add about a week on the front end. Call (833) 700-4611 and we’ll give you a written range before anyone touches your wall.

How Door Installation Actually Runs, Day by Day

Tight lots and shared walls mean sequence matters in Emeryville. Here’s the order we hold to.
1. Site measure and swing check (same visit as the estimate)
We measure the rough opening, check the wall for plumb and square, and look at how the door swings relative to stairs, counters, and the neighbor’s fence line. In a live-work loft where a door lands three inches from a working wall, that half hour of measuring is what keeps the install from turning into a remodel. You decide rough-in size and swing direction here.
2. Material order and lead time (1 to 4 weeks)
Stock slabs and standard pre-hung units arrive in days. Custom sizes, stained finishes, and fiberglass entries with sidelites run longer. You lock the material spec during this window – more on that below – because once the order goes in, changing it costs money and calendar time.
3. Demo and prep (half day)
We pull the old door and casing, cut back any rot at the sill or jamb, and check the header. Older warehouse shells and mid-century stock around Powell Street regularly turn up shimmed frames and settled headers, so we allow time to reframe a rough opening rather than force a new door into a crooked one.
4. Hanging and hardware (one full day)
The new unit gets shimmed, plumbed, and anchored, then we set locksets, deadbolts, hinges, closers, and weatherstripping. Sealing the exterior perimeter with backer rod and high-grade sealant happens the same day – a door that’s set but not sealed will leak in the first winter rain.
5. Inspection and finish (day 3 to day 5)
If the project triggered a permit, the rough opening and egress clearances get inspected before we close up trim. Then final casing, paint or stain, threshold adjustment, and a walkthrough where we make sure the latch catches clean and the door doesn’t drag. You decide finish schedule at this stage.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
- Hollow-core slab: The cheapest interior option at roughly $250 to $500 installed. Fine for closets and bedrooms, but it dents and won’t do in a hallway that gets daily traffic.
- Solid-core interior: $500 to $900 installed. Heavier, quieter, and holds up to kids and dogs. This is the upgrade most Emeryville townhome owners pick once they hear the difference in sound.
- Fiberglass exterior entry: $1,200 to $2,800 installed. Doesn’t rot, resists the bay breezes, and takes a stain or paint finish. Best fit for exposed west-facing entries.
- Steel exterior and security doors: $900 to $2,200 installed. Heavier and more burglar-resistant, but steel dents and needs periodic paint. Common on alley-load and ground-floor units where security is the priority.
- Wood exterior entry: $1,500 to $2,600 installed. Beautiful grain, needs annual maintenance in this climate. Marries well with older mid-century building stock.
- Hardware and openers: Deadbolt grade, keypad locks, and rolling-code remotes vary widely – a rolling-code opener eliminates the fixed-code vulnerability that older remotes carry.
What Door Installation Costs in Emeryville, CA
Here’s the honest range, calibrated to what we see in this market.

| Door type | Installed range |
|---|---|
| Interior slab, hollow-core | $250 – $500 |
| Interior solid-core | $500 – $900 |
| Exterior fiberglass entry | $1,200 – $2,800 |
| Exterior steel / security | $900 – $2,200 |
| Wood exterior entry | $1,500 – $2,600 |
| Garage service door | $600 – $1,800 |
What pushes a job to the top of that range: a non-standard rough opening that needs reframing, rot or termite repair at the sill, relocating a strike plate or adding a security deadbolt, an upgraded finish, and whether a permit is triggered. What’s in a written estimate from us: the unit, hardware, sealant, labor, haul-away, and permit pull where required. What typically isn’t: repairs found behind the wall, paint matching on existing trim, and HOA fees if your building requires archtectural review. No surprises – the number you see is the number you pay, backed by the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Emeryville Homes Specifically Do to This Job
Emeryville’s housing stock is a patchwork. You’ve got aging WWII-era and mid-century industrial and warehouse shells sitting next to 1990s-2000s live-work lofts and the newer mid-rise towers around the Bay Street and Powell Street corridors. Much of the work here is infill redevelopment and adaptive reuse, not new single-family construction. That changes door installation in three ways. First, tight lots mean little staging room – our installers plan material delivery around parking and access from day one. Second, old warehouse frames and converted shells rarely have square openings, so reframing is a routine phase, not an exception. Third, the city’s layered entitlements and environmental review can slow permits more than in neighboring Berkeley or Albany, so we build permit lead time into every schedule. And on the security side, alley-load and townhome entries need rolling-code openers and grade-rated deadbolts – fixed-code remotes are a real weakness on ground-floor units.
Serving Emeryville, CA – Our Local Coverage Area
We serve Emeryville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Emeryville

A single interior door is a half-day job; an exterior entry with framing repair is typically two to three days, plus one to four weeks of material lead time. If a permit is required, add about a week on the front end. Call (833) 700-4611 for a schedule estimate matched to your door.
Interior door swaps generally don’t need a permit, but exterior entries, changes to the rough opening, or egress-related changes often do. We pull the permit and get the inspection passed where it applies. Call us and we’ll tell you upfront whether your specific door triggers one.
Yes in most cases – a straight swap reuses the existing rough opening and hits the low end of the range. The job changes only when the opening is out of square or the wall contains plumbing or wiring that has to move. That’s why we measure first.
Interior doors run $250 to $900 installed; exterior entries run $900 to $2,800 installed, with a garage service door at $600 to $1,800. Reframing, rot repair, and upgraded hardware push the number up. Call (833) 700-4611 for an exact quote – estimates are free.
Every door we install is covered by our 730-Day Done Right Promise – if the fit, finish, or hardware fails, we make it right, not just the minimum one year other crews offer.
Get a Free Door Installation Estimate in Emeryville
Whether you’re replacing a single bedroom slab or hanging new exterior entries with rolling-code openers on a townhome, we’ll give you a written line-item range for Door Installation in Emeryville before you commit. Call (833) 700-4611 – a live person answers around the clock, and we’ll schedule a free on-site estimate, walk the openings with you, and hand you a fixed-price quote backed by the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












