







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Martinez, CA: What the Job Actually Involves
Paver driveways in Martinez, CA run $7,000 – $18,000 for a typical residential installation, and most jobs take three to five working days once materials are on site. The work is excavation, a compacted aggregate base, edge restraint, then the paver field set in bedding sand and finished with polymeric joint sand. Call (833) 700-4611 and we’ll walk your slope and give you a written line-item estimate. Every install is covered by our 730-Day Done Right Promise.

How a Paver Driveway Goes In, Stage by Stage

Every Martinez driveway we build follows the same sequence. Timelines shift with slope and access, but the order never changes.
Day 1: Layout and demolition
We mark the finished grade, confirm the slope away from the garage, and cut out the old surface. A standard two-car apron comes up in a day. Asphalt or concrete hauls off in the same window. You decide the edge restraint type before we cut: hidden plastic edge, or a soldier course of pavers set in concrete. The concrete-set option adds cost and about half a day, but it holds a slope better.
Days 1 – 2: Excavation and base
This is the stage that decides whether your driveway lasts twenty years or five. We dig to a depth that gives you 6 to 8 inches of compacted Class II aggregate under the pavers. On the hillside lots above downtown, base depth often goes deeper on the uphill side to key into stable soil, and that’s where the schedule stretches. Each lift gets compacted, then graded. A laser check confirms fall to the street.
Day 2 or 3: Inspection window
If the job triggers a grading or right-of-way permit, the base inspection is where Martinez’s plan reviewers want to see it. We schedule that inspection before any sand goes down. Skipping it and pleading later doesn’t work in this town.
Days 3 – 4: Setting the pavers
Bedding sand screeded to an even inch, then the field laid from a string line. A standard driveway lays at roughly 300 to 500 square feet a day with a two-person crew, slower on a herringbone pattern than a running bond. You choose the pattern up front because it changes both labor and waste allowance. Herringbone typically loses 8 to 10 percent to cuts; running bond closer to 5.
Days 4 – 5: Edging, joint sand, cleanup
Edge restraint goes in, the surface gets compacted a final time, polymeric sand fills the joints, and we sweep and rinse. You can drive on it the next morning. We do a walkthrough before we leave: joint sand depth, drainage, the transition at the garage slab and the sidewalk.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Most of the decisions land before demolition. Here’s what buyers weigh, with the honest trade-offs.
- Concrete pavers vs. clay brick. Concrete pavers are the workhorse: the widest color range, typically $8 – $14 per square foot installed here, and they shrug off freeze-thaw. Clay brick costs more, holds color longer, and suits the Victorian facades near downtown. Pick brick if you want character that ages well; pick concrete if budget and durability lead.
- Thickness. 60mm pavers are fine for a residential driveway. Step up to 80mm on a steep pitch or where a heavy truck parks. The upcharge is modest and worth it on the hillside.
- Pattern. Running bond is the value play. Herringbone and basketweave look better and resist tire shear, but cost more in labor and cut waste. Herringbone on a driveway that sees turning wheels pays for itself.
- Permeable systems. Open-graded joints and a drainage base let water sheet into the soil instead of the storm drain. Useful on lots with poor drainage or where a hard surface would otherwise shed water onto a neighbor.
- Color and finish. Tumbled edges read older and softer, straight edges cleaner and more modern. Belgard offers a deep catalog if you want to match a specific house. We’ll lay samples on your actual driveway so you see the color in Carquinez light, not under showroom bulbs.
What Paver Driveways Cost in Martinez, CA
Plan on $7,000 – $18,000 for a full paver driveway installation in Martinez. That range covers a standard two-car drive from excavation through joint sand. Five variables push a job toward either end:
- Square footage. The biggest lever. A 400-square-foot apron sits at the bottom; 800 square feet or a long hillside run lands at the top.
- Slope and grading. Alhambra Valley and hillside lots need deeper base, retaining or keying, and sometimes a drainage swale. That’s real excavation time.
- Existing surface. Removing an old concrete slab costs more than grinding asphalt, and hauling adds dump fees.
- Material grade and pattern. Clay brick and complex patterns sit high; concrete running bond sits low.
- Permit scope. Right-of-way work or grading review adds plan-check time and fees.
A written estimate itemizes demo, haul-off, base depth, drainage, edge restraint, pavers, polymeric sand, and permit fees. What it typically doesn’t cover: unexpected utilities under the footprint, or a failed base discovered mid-dig. We flag those the moment they surface, and the number on our upfront pricing doesn’t move without your approval. No change-order surprises. Permeable work and any wall or grading run as separate line items so you can see what you’re paying for.

See the difference
Before
After
Before
After
Before
AfterWhat Martinez Homes Do to This Job
Martinez is a wind gap. The Carquinez Strait funnels afternoon gusts off the Delta, and that shapes a paver install here in ways flatland towns don’t see. A dry bedding-sand surface blows out before it’s compacted, so we schedule sand-screeding and paver-laying for morning, when the wind is calm. On exposed hillside drives above downtown, we also spec a heavier edge restraint and a deeper base key, because a driveway that sheds wind and water on a slope fails differently than one on the flats.
The housing stock matters too. The Victorian-era homes in the downtown core sit on tight lots where access to the footprint is narrow. Mid-century ranches on the flats have wider aprons and easier dig. Custom hillside homes in Alhambra Valley need slope stabilization and drainage designed in before a single paver is set. On the permitting side, Martinez City Hall reviewers look hard at grading plans because of the 1980s slope failures in the hills above downtown, so budget extra plan-check time if your driveway involves regrading. Where the driveway ties into a larger exterior project, this is part of a full Driveway & Pavers in Martinez scope, and homeowners often pair the new drive with Door Installation in Martinez to finish the front of the house. If the project widens into kitchen work, we also handle Cabinets & Countertops in Martinez.
We cover the whole 94553 ZIP and the surrounding Martinez area, and our broader Driveway & Pavers service handles everything from patios to walkways when your project grows past the apron.
Serving Martinez, CA – Our Local Coverage Area
We serve Martinez and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in Martinez

Most paver driveways in Martinez finish in three to five working days, weather permitting. Demolition and excavation take a day, base work and compaction another, laying the field one to two days depending on square footage and pattern, then a final day for edge restraint, polymeric sand, and cleanup. Hillside lots with deep base or a grading inspection stretch that schedule. Call (833) 700-4611 for a timeline built around your specific slope.
Many do, and it depends on what the drive touches. A straight replacement within your existing footprint may not need one. Anything that changes grade, widens into the right-of-way, or adds retaining or drainage will trigger review, and Martinez reviewers scrutinize hillside grading plans closely. We pull the permits and see the inspections through as part of the job. Call (833) 700-4611 and we’ll tell you what your driveway needs.
We don’t recommend it. A paver driveway that’s set over a failing slab telegraphs every crack within a couple of seasons. The base is the whole game, and the honest way to get a base is to excavate to the right depth. Occasionally a sound slab can be left and a thin paver layer set over a proper leveling course, but that decision gets made on site after we probe the existing surface. Call (833) 700-4611 to schedule the look.
Paver driveway installation in Martinez runs $7,000 – $18,000, driven by square footage, slope and grading, existing surface removal, material grade, and permit scope. A flat mid-century ranch drive lands low; a steep Alhambra Valley lot with deep base and drainage lands high. Call (833) 700-4611 for an exact written quote, free estimates on site.
Every paver driveway we build is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If a base settles or a paver lifts, we make it right within that window. Paver manufacturers also carry their own product warranties, which we hand you in writing. Call (833) 700-4611 to get the estimate started.
Get a Free Paver Driveway Estimate in Martinez
Call (833) 700-4611 for a free on-site estimate on your paver driveway in Martinez. A live person answers, day or night, and we schedule the walkthrough around your slope, your square footage, and your timeline. We measure the footprint, probe the existing base, talk through pavers and patterns, and hand you a written line-item quote with upfront pricing and no change-order surprises. From foundation to finish line, it’s one contractor and one guarantee: built to last, backed in writing.
Written by the team at Groundwork Construction Co.












